fastline
Senior Member
- Location
- midwest usa
- Occupation
- Engineer
Have a rush job where I need to get some industrial lighting installed. two adjoined buildings are 260ft long and plan for only a single light at the center of each bay. We will probably break each building into two circuits so my intent is to run 4 conductors half way, then 2 conductors the rest of the way. We have not decided if EMT or MC will be used but I wanted to ask about colors for this? Is tape acceptable for color coding? I ask because if we go with MC, I am not sure what colors are even available.
The circuit is likely to be #14 wire.
We would be attaching to the very top roof purlin with a JB mounted for every light location and cable or EMT will be attached to said purlin. We will have to jog a short distance (3ft) to each light so if we do EMT, we would probably have to transition to MC for that jog. Just sharing the plan.
The circuit is likely to be #14 wire.
We would be attaching to the very top roof purlin with a JB mounted for every light location and cable or EMT will be attached to said purlin. We will have to jog a short distance (3ft) to each light so if we do EMT, we would probably have to transition to MC for that jog. Just sharing the plan.