With the disconnect switch adjacent to the structure How do you typically install your feeder to the interior panel?
If you show up and the trailer is set up onsite, you can’t trench to the location where the interior panel is located.
previously I’ve dug my feeder until it’s under the trailer then came to surface under trailer and sleeved the feeder under the trailer on the surface of the ground (usually on the plastic vapor barrier) with ENT until I get to the pvc conduit riser where the panel is located and coupled the pvc to the ent.
If you show up and the trailer is set up onsite, you can’t trench to the location where the interior panel is located.
previously I’ve dug my feeder until it’s under the trailer then came to surface under trailer and sleeved the feeder under the trailer on the surface of the ground (usually on the plastic vapor barrier) with ENT until I get to the pvc conduit riser where the panel is located and coupled the pvc to the ent.
